HOW THE OBJECTS DO NOT LOOK AT THE FLOOR

Method 1: The object is outside the View Range (VR) area

Calling VR command appears voicemail

Primary Range:

Top: the highest altitude

Cut Plane: is the plane representing the 2D plane of the object, for that object to display on the plane, the Cut Plane must at least cut through it or lie higher than it. Therefore, the object cannot be seen at any level because Cut Plane is lower than the object height. How to create a section to view the altitude of the object, then adjust the measurements in the Offset section of the Cut Plane. Note when changing the Offset Cut Plane so that the Cut Plane is not outside the Top and Bottom areas

Bottom: lowest pitch

View Depth

Level: high sound level

How to adjust: Top select the highest altitude, Bottom select the lowest pitch, Offset of Top and Bottom as shown

Method 2: Open the VG- Find the name and attribute of the hidden object, then open select. The picture below is hidden from walls and floors

EN BIM VIETNAM

Free online learning channel